300C Studio Flash
OWNER’S MANUAL
(1) AC Power Supply Socket
(2) Safety Fuse
Light Body & Rear Control Panel
(3) Synch Cord Socket
(4) General power supply on/off switch
(5) Modeling Lamp on/off switch
(6) Power setting for modeling lamp on/off switch
(7) Recharge Ready-Light
(8) Slave Sensor
(9) Handle Grip
(10) Audio signal for recharge ready on/off switch
(11) Lock/Release Bolt for reflector & softbox connector
(12) Test button
(13) Output Power Setting for flash/ modeling lamp
(14) Hand Wheel for angle adjustment
(15) Stand Mount
(16) Stand Mount Bolt
(17) Umbrella Holder
(18) Modeling Lamp
(19) Replaceable Flash Tube
Directions for use
1ꢀ Turn on the Light
Turn on the power supply by pressing down the power button
(4). The recharge ready light (7) will turn red light when the
flash has been fully charged.
2ꢀ Test Flash
Press the test button (12) to make sure the flash is working.
3ꢀ Slave Sensor
You can use the built-in slave sensor to trigger the light.
4. Synch Cord
Link the studio flash to your camera with a synch cord to
9. Replacing flash tube
Wear gloves whenever removing the flash or modeling lamp.
When replacing the flash tube, first remove the modeling lamp,
then insert the flash tube. DO NOT TOUCH the anode OR
cathode of the flash tube.
trigger the light. You may also use the built-in slave sensor to
trigger your flash.
5. Audio Signal
Setting the audio signal button (10) to the ON (I) position will
activate an audio signal to remind you when the flash has
been fully recharged. Set the button to the OFF (O) position
will disable the audible signal.
Package includes:
Description
QTY
6. Modeling Lamp
PROMASTER SystemPRO 300C Flash
15' Power Cable
1
1
1
1
1
1
1
To turn the lamp off, set the switch (5) to “0”. When set to "=",
the modeling lamp is on at full power. When set to the "-"
position, the modeling lamp varies in brightness as you turn
the output control button (13). Press the DIM switch (6) to the
"I" position and the modeling lamp will turn itself off when the
flash is fired and then will turn on automatically when the flash
is fully charged.
15' Synch Cord
7" Standard Reflector
150W Modeling Lamp
Protective Cover
Owner’s Manual
7. Adjust Output Power for Flash
Use the flash power adjustment knob (13) for the desired
exposure. The power level can be set continuously from 1/32
to full power.
8. Attaching the Reflector
The reflector has 3 pins around the perimeter of its base. Line
these pins up with the corresponding notches in the flash head
front collar. Rotate the reflector clockwise until it locks into
position To remove the reflector, push the locking lever on the
top of the flash head and rotate the reflector counter clockwise,
then pull it way from the flash head.
|